TST100 Firmware Errata

From Wiki Knowledge Base | Teltonika SAS
This is the approved revision of this page, as well as being the most recent.
Main Page > SAS Micro Mobility > TST100 > TST100 Firmware Errata

Introduction

We are always improving our devices performance, stability and reliability. That’s why Teltonika is one of the leading GNSS trackers manufacturers in the world. This document describes TST100 devices firmware improvements, changes, new features implementations as well as current firmware release version.


Firmware versioning

  • Structure
 FMB.VER.[XX].[YY].[ZZ].Rev.[##] _ID[###]
  • Syntax description
    • XX – major FW version.
    • YY – branch number - shows major changes in firmware, i.e. new module support added or new major feature added.
    • ZZ – major changes like bigger fixes, improvements and new features addition.
    • ## – minor changes like small fixes and improvements.
    • ID[###] – Spec ID KEY – Specific clients FW ID.



Firmware versions

FIRMWARE VERSION RELEASE DATE CHANGES
03.25.05.Rev.130

(Current firmware release version for TST100)

2020.03.25
  • Optimized e-scooters' Master Control and Instrument Panel FW queries;
  • Optimized e-scooters' Instrument Panel FW update sequence;
03.25.05.Rev.129
2019.12.06
  • Optimized communication between e-scooter ant TST100;
  • E-scooter will update even if heartbeat wasn't detected;
  • Bluetooth disabled by default;
03.25.05.Rev.126 2019.09.18
  • Added internal Segway ES2/4 and MAX autodetection to prevent wrong scooter Firmware update;
  • Added option None as default to Scooter Protocol parameter + Serial number requesting as separate function;
03.25.05.Rev.121 2019.08.29
  • Added Xiaomi support;
  • Optimized Fall down scenario on Xiaomi;
  • Optimized Ignition status on Xiaomi;
  • Codec8 Extended set by default;
  • Scooter Firmware update made independent from enable FW versions IOs;
  • Implemented segway Firmware update on 1st connection;
  • Implemented data reading from internal/external battery;
  • Improved scooter engine control command;
  • Updated Segway Ninebot protocol;
  • Updated scooter data requesting;
  • Scooter data reading and reset improvements;
  • Improved responses to scooter control commands;
  • Enabled FallDown/Unplug features;
  • Added FallDown Timeout parameter, changed trace messages from ManDown to FallDown;
  • Unified modes select in scooter commands;
  • Added buzzer control support for TST100;
  • Added scooter as odometer source;
  • Improved scooter commands execution;
  • Added TST100 hardware support and partial functionality;