TST100 Features settings

From Wiki Knowledge Base | Teltonika SAS
Main Page > SAS Micro Mobility > TST100 > TST100 Configuration > TST100 Features settings

Jamming

TST100 Jamming.png

When jamming is detected the scenario is activated, an event record is generated status is changed to 1 when configured once Jamming timeout runs out. If jamming ends during timeout countdown no event will be generated. Eventual Records parameter can be configured: when it is disabled scenario status value will appear in each AVL record, otherwise it will be appended only to eventual records.

FallDown

TST100 Fall Down.png

An event will be generated when TST100 left in certain position

  • Angle - determines and which angle event is generated (e-scooter dropped on the ground)
  • Timeout - time until even is generated

Unplug Detection

TST100 Unplug Detection.png

An event will be generated when TST100 is unplugged from external power or plugged back in again.

Scenario settings

  • Disable - disable scenario.
  • Low Priority - when low priority event is triggered, device makes additional record with indication of event cause.
  • High Priority - module makes additional record with High priority flag and sends event packet immediately to the server by

GPRS

  • Panic Priority - triggers same actions as High priority, but if GPRS fails, it sends AVL packet using SMS mode if SMS is enabled in SMS Data Sending settings.

Eventual records

  • Disable - scenario status value is sent in each AVL record.
  • Enable - scenario status value is sent only in eventual AVL records.

Unplug Detection mode

  • Simple - unplug detection according to external voltage only. Is used in kick e-scooters where power voltage is not dependent on ignition (recommended).
  • Advanced - unplug detection according to external votage and accelerometer. Is used in kick e-scooters where power voltage is disconnected when ignition is switched off.

Buzzer control

  • Enable - buzzer will be active if unplug detected
  • Disable - buzzer disabled and won't activated if unplug is detected
  • Buzzer ON duration in seconds - determines how long buzzer will be active when unplug is detected (min 0 , max 65535)