TMT250 Auto Geofence settings

From Wiki Knowledge Base | Teltonika SAS
This is the approved revision of this page, as well as being the most recent.
Main Page > SAS Personal Trackers > TMT250 > TMT250 Configuration > TMT250 Auto Geofence settings
Tmt250 autogeofence.png

AutoGeofence is based on the last known position after the movement has stopped. You can be notified using this function if your machine is taken away. The shape and size of Geofence zones are set by parameters. It is possible to state whether entering or leaving the geofence triggers an asynchronous message. AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure.
Activation timeout defines the delay between the creation of AutoGeofence within set Radius value around machine's most recent position and when the ignition is off. Activation timeout is not configurable via configurator, by default 60 second value is used. Scenario can be activated through a SMS/GPRS command or by a configured button and can be disabled by SMS/GPRS, button or call. To disable scenario with a call, configure Incoming Call Settings to Auto Geofence Off and set authorized numbers if such are used. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility. Event generation can take place on Geofence Entrance, Exit or On Both. Eventual Records is used to enable or disable Eventual Records functionality.

  • Digital Input 1 – If DIN1 voltage becomes equal or higher than 6.9 V.
  • Power Voltage – If power voltage becomes higher than low voltage level (defined in Ignition settings).
  • Engine RPM – If engine RPM value becomes higher than 0.